Dimension too large
Moderator: andrew
2 posts
• Page 1 of 1
Dimension too large
by Z.K. » Wed Sep 21, 2011 8:28 pm
I drew an object in .1/1 scale and when I add dimensions, they are almost larger than the drawing. I can't seem to change the properties or attributes of the dimension and I tried editing the layer properties of my dimension layer, but it was already on the smallest setting. Any Ideas?
- Z.K.
- Posts: 7
- Joined: Wed Sep 21, 2011 8:14 pm
Re: Dimension too large
by Z.K. » Wed Sep 21, 2011 8:38 pm
Z.K. wrote:I drew an object in .1/1 scale and when I add dimensions, they are almost larger than the drawing. I can't seem to change the properties or attributes of the dimension and I tried editing the layer properties of my dimension layer, but it was already on the smallest setting. Any Ideas?
Never mind, I figured it out. I had to use the drawing preferences.
- Z.K.
- Posts: 7
- Joined: Wed Sep 21, 2011 8:14 pm
2 posts
• Page 1 of 1
Return to QCAD Community 'How Do I' Questions
Who is online
Users browsing this forum: No registered users and 1 guest