Page 1 of 1
3d
Posted: Thu Jan 22, 2009 4:47 pm
by jeffreyrreiser
Are there any future plans to build 3d into the software?
Posted: Thu Jan 22, 2009 4:59 pm
by andrew
No
3d Solution
Posted: Thu Jan 22, 2009 5:06 pm
by jeffreyrreiser
Is there a preffered method of adding 3d capability to qcad. Sketch-up?
Posted: Fri Jan 23, 2009 11:16 am
by andrew
This depends of course on your specific application. For building designs, SketchUp might be a good choice. Otherwise anything that imports 2d DXF files should work (try the data exchange via DXF first, not all DXF implementations are complete).