Page 1 of 1

A typing mistake

Posted: Sun Mar 22, 2009 9:18 pm
by OldAl
I just started the evaluation of QCAD. I am very impressed with what I see! (But I have not yet seen much :) ).
No doubt in the help pages there are typos. An example: In section 6.8 Modes, paragraph "Normal Mode" second last line is:

if in normal more, you can ...
Of course, it should read:
if in normal ** mode **, you can ... without **, of course.

Q question: I like to have the help pages on hard copy: Can the print size be increased? It is microscopic, at the moment. My eyes are not as good as they used to be and I can only read the hard copy through ... a printers' microscope.

OldAl.