QCAD.org Forum

Skip to content

Intersecting Lines

Use this forum to ask questions about how to do things in dxflib.

Moderator: andrew

Post a reply

Intersecting Lines

Postby tchiz » Wed Jun 18, 2008 5:24 am

How do I draw intersecting lines that are not supposed to touch each other? As in a wire diagram, where two wires cross, but are not supposed to touch each other.
tchiz
 
Posts: 7
Joined: Wed Jun 18, 2008 5:19 am
Top

Postby andrew » Wed Jun 18, 2008 9:57 am

Is this a question about dxflib or QCad?
andrew
Site Admin
 
Posts: 1842
Joined: Fri Mar 30, 2007 6:07 am
Top

Intersecting Lines

Postby tchiz » Wed Jun 18, 2008 10:36 pm

It is about QCAD
tchiz
 
Posts: 7
Joined: Wed Jun 18, 2008 5:19 am
Top

Re: Intersecting Lines

Postby andrew » Wed Jun 18, 2008 11:00 pm

tchiz wrote:It is about QCAD


OK - please post your question again in one of the QCad forums if you don't mind. This is a dxflib forum.

You can find the overview over the forums here:
http://www.ribbonsoft.com/rsforum/

Thanks
andrew
Site Admin
 
Posts: 1842
Joined: Fri Mar 30, 2007 6:07 am
Top
Post a reply

Return to dxflib 'How Do I' Questions

Who is online

Users browsing this forum: No registered users and 2 guests

Powered by phpBB® Forum Software © phpBB Group