Page 1 of 1

Parallel line tool please?

Posted: Wed Feb 24, 2010 12:45 pm
by ttrw
Andrew, can we have a proper parallel line tool?

I hate having to go over lines all the time to make them parallel, with the existing tool. It would speed things up if there were an option so this could just be done in one shot as well? This would be a really useful tool for architectural visualising etc- drawing frames etc.

regards,

Tom

PS, no noise from you guys in ages! Where are the new QCad updates?! :? :D

Posted: Tue Aug 24, 2010 10:03 am
by kasper
I agree with Tom. A tool that creates polylines with a given distance to each other would be very nice. In fact in the pro edition you are allready close, with the polyline and the equidistant. It's just that last step to create immediately a closed polyline.

Regards, kasper