Edit/Chamfer or Edit/Round button pressing

Please use this forum to post feedback and suggestions related to QCAD Professional.

Moderator: andrew

Locked
Latch
Newbie Member
Posts: 4
Joined: Tue Feb 15, 2011 4:57 pm

Edit/Chamfer or Edit/Round button pressing

Post by Latch » Sat Feb 19, 2011 5:47 pm

With an accidental 2 button press on either the Chamfer/Bevel button or the Round button it is possible to get Radius, Length 1, Length 2 to all show up on the Options Toolbar together.
It can happen when switching between these two buttons.
There seems to be no effect on the results of either intended operation, but it is a bit confusing if it happens.

Locked

Return to “QCAD 2.1/2.2 Suggestions and Feedback”