Additional Commands
Posted: Tue Mar 18, 2008 4:00 pm
Dear Sirs,
I am very pleased with qcad, but would like to see the following two mods on the next version.
Can you add the ability to create an 180 degree arc using two points on its diameter. This would work similar to creating a circle using 2 points.
Can you allow the user to customise the layout of the icons.
Is there any release date for the next version ?
Regards
IsoCAM
I am very pleased with qcad, but would like to see the following two mods on the next version.
Can you add the ability to create an 180 degree arc using two points on its diameter. This would work similar to creating a circle using 2 points.
Can you allow the user to customise the layout of the icons.
Is there any release date for the next version ?
Regards
IsoCAM