Please use this forum to post feedback and suggestions related to QCAD version 3
I would very much like to see a group / ungroup tool in Qcad 3.
- Junior Member
- Posts: 17
- Joined: Tue Nov 25, 2008 12:36 pm
Groups are called 'blocks' in CAD / QCAD.
In other words, a block is a named, reusable group.
- Site Admin
- Posts: 3856
- Joined: Fri Mar 30, 2007 6:07 am
In addition, in CAD/QCAD 'Blocks' can be exploded to break them back down again into single entities (lines, arcs and so on). In QCAD quite simply select the block in question and
go to > Main Menu > Modify > Explode.
Essentially this is the same as 'un-grouping' in say Illustrator!
- Moderator / Drawing Help
- Posts: 1145
- Joined: Thu Aug 25, 2011 9:28 pm
- Location: UK
Return to QCAD 3 Suggestions and Feedback
Who is online
Users browsing this forum: No registered users and 1 guest