Page 1 of 1

Find the center of a polyline arc segment ...

Posted: Sun Dec 08, 2013 12:29 am
by Husky
I learned that it can be very difficult to find the center of an arc segment in a Polyline.
The Autosnap has understandable problems but I can't see why I have to search so long with the "Center SC" snap in a blanc area to find - by accident - the center.
Would it be possible and maybe also in my understanding more logical to find the center with just a mouse-over / selecting the Polyline arc segment like the normal arc line?
Husky-2013.12.07-05.png
Husky-2013.12.07-05.png (3.5 KiB) Viewed 5301 times
Here a Test dxf - try to find the center of the biggest Polyline arc segment. The small arcs are easy ... :wink:
Center Test.dxf
(80.14 KiB) Downloaded 483 times

Re: Find the center of a polyline arc segment ...

Posted: Sun Dec 08, 2013 12:31 pm
by andrew
Thanks for your report.

A polyline is one entity and snap to center is currently defined for polylines as:
- snap to the closest one of all the center points of the polyline

This has been improved for the next release to:
- snap to the center point of the closest segment of the polyline

Re: Find the center of a polyline arc segment ...

Posted: Sun Dec 08, 2013 7:54 pm
by Husky
andrew wrote:This has been improved for the next release to:
- snap to the center point of the closest segment of the polyline
Sounds good to me - we will see how good it works in the next release. Thank you for taking care of it!