Layer 'Start up' suggestion
Posted: Thu Mar 13, 2014 1:34 pm
When we open an existing drawing in QCAD the layer 'O' is always our starting base, I am wondering whether a new option in our layer set-up dialog to choose which layer an existing drawing starts with the next time we open it and could be changed as often as we need, would be possible!
Being a 'non' programmer I don't know if this would be at all possible with QCAD, but if it was it would sure be a bonus
Andrew
Is this possible and relatively straight forward to implement?
Do others have any ideas on this ?
Being a 'non' programmer I don't know if this would be at all possible with QCAD, but if it was it would sure be a bonus
Andrew
Is this possible and relatively straight forward to implement?
Do others have any ideas on this ?