30tooo wrote:Thats the badger......
Okay - good, we got there in the end
Well as Husky correctly points out the 'magic' button to do it all for you in QCAD is hopefully in development... and looking at the 'Bugtracker' - which is also used for submitting feature requests too - this seems to be the case:http://www.qcad.org/bugtracker/index.ph ... ask_id=858
For me I often overlook the fact to mention that I use construction lines, circles and geometric principles to get the job done when I haven't got 'that particular' dedicated tool in QCAD to do it for me - thank you Husky for pointing that out
Back to your question, basically I set up the circle tangents and the arc based on my
sizes, what would be good is if you can post an example drawing with exact dimensions and positions of the circles and the 'restricting' line.
Regarding the arc - is the radius size important or
does it just have to fit and look right ?
Regarding 'snapping' to the line - again does it just have to fit or
snap to an exact coordinate point ?