Hi
im having a bit of trouble drawing the holes I need on the attached part, I have been able to do the vertical and horizontal ones but I cant figure out how put the holes on the angled section of the job, the need to be running parallel with the sides 25mm in, if someone could tell me how/or what function I should be using I would be very grateful
I have attached the file and also I have attached a photo of the physical template im working off.
Any comments or suggestions would be greatly appreciated.
Cheers
Matt
aligning holes
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
aligning holes
- Attachments
-
- A1.dxf
- (28.1 KiB) Downloaded 301 times
Re: aligning holes
Hello Matt - welcome to the forum!
Then I would copy one hole (circle) to the clipboard what brings me into the position to use the "Paste along entity" tool.
What do you think - will that help?
For the 25 mm offset I would use the Modify tool "Offset with distance",aklweld wrote:Hi
im having a bit of trouble drawing the holes I need on the attached part, I have been able to do the vertical and horizontal ones but I cant figure out how put the holes on the angled section of the job, the need to be running parallel with the sides 25mm in, if someone could tell me how/or what function I should be using I would be very grateful ...
Then I would copy one hole (circle) to the clipboard what brings me into the position to use the "Paste along entity" tool.
What do you think - will that help?
Work smart, not hard: QCad Pro
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Re: aligning holes
that was exactly what I needed, thanks husky
cheers
matt
cheers
matt