Page 1 of 1

QCAD3 RC2 Issue copy with reference (maybe)

Posted: Fri Dec 16, 2011 3:56 pm
by cmcgrath5035
I select several entities, the select edit-copy with reference

I don't see a prompt to enter reference like ver 2.2 had, but if I just enter 0,0 in the command area it does seem to work.

Likewise, when I paste it on a different layer, there is no prompt to enter reference, but entering 0,0 does give the correct result.

Perhaps I am not reading the bottom row of the window properly?

Posted: Fri Dec 16, 2011 4:45 pm
by andrew
I've posted a bug report:
http://www.ribbonsoft.com/bugtracker/in ... ask_id=436

Note that the tools work properly but they do not change the command line prompt as expected.