Numbers don't show on Command Line

Use this forum to ask questions about how to do things in QCAD 2.1/2.2.

Moderator: andrew

Locked
binto100
Registered Member
Posts: 2
Joined: Thu Feb 18, 2010 6:19 pm

Numbers don't show on Command Line

Post by binto100 » Thu Feb 18, 2010 6:29 pm

Numbers I enter on the Command Line do not show up once the command is executed.

For example I enter @0,0 in the Command Line for the start of a two point line and press enter. The line starts correctly at the relative reference but @0,0 does not show in the Command Line history. Then I enter the end point via the Comman Line and again those numbers do not apprear in the Command Line history.

Any help would be appreicated. Thanks.

Bruce
Win7, Qcad 2.2

Locked

Return to “QCAD 2.1/2.2 'How Do I' Questions”