Hello!
Hope this is the correct forum.
I use Qcad 2.2.2.0 and I need to draw some blueprints for my garageproject.
I got two questions:
1)
I find it pretty hard to create an exact rectangle.
Is there a way to create a rectangle through a dialog box like set:
x = 0
y = 20
width =100
height=100
Or is there a smarter way to create a rectangle?
2)
I also wonder if I can change the dimension for the axis x and y axis and for the mesh?
Best regards
Fredrik
QCad How to create a rectangle?
Moderator: andrew
Re: QCad How to create a rectangle?
1. Set the 1st corner point of the rectangle using an appropriate snap tool.fredand44 wrote: 1)
I find it pretty hard to create an exact rectangle.
Is there a way to create a rectangle through a dialog box like set:
x = 0
y = 20
width =100
height=100
2. Set the 2nd corner point with coordinate snap (Snap - Coordinate). Enter a relative coordinate in the options tool bar, e.g. x: 100, y: 100
The key thing here is to use relative coordinates.
You can find the grid settings in Edit - Current drawing preferences.fredand44 wrote: 2)
I also wonder if I can change the dimension for the axis x and y axis and for the mesh?