Importing DXF-file to QCAD.
Posted: Thu Jun 30, 2011 10:19 am
Hello!
After an import of a DXF-file from Autocad(?) I tried to draw a line
between two points. The snapin worked good, but the line was
drawed 10-20 times to long, so it seems that is a problem with
scaling. It is possible to give the drawing the right scale in some way?
Thanks in forward
ostene
After an import of a DXF-file from Autocad(?) I tried to draw a line
between two points. The snapin worked good, but the line was
drawed 10-20 times to long, so it seems that is a problem with
scaling. It is possible to give the drawing the right scale in some way?
Thanks in forward
ostene