How do I trim?? Query from a newbee
Posted: Sun Oct 28, 2007 3:00 pm
Hi Qcaders:
I'm a Qcad newbee interested in drafting for my home cabinetry projects. Here is a question:
I made a square that is 25 x 25 and then drew a 315 degree angle from the 12.5,25 point. The angle intersects that upper right corner of the square, and extends beyond the right- side of the square.
I want to:
1. trim the upper right corner of the square that is "cut off" by the angle, and then
2. trim the segment of the angle line that extends beyond the right-side of the square.
How do I do this? I'm new to Qcad and cad in general.
Thank you!
Phil Smith
Duluth, GA
I'm a Qcad newbee interested in drafting for my home cabinetry projects. Here is a question:
I made a square that is 25 x 25 and then drew a 315 degree angle from the 12.5,25 point. The angle intersects that upper right corner of the square, and extends beyond the right- side of the square.
I want to:
1. trim the upper right corner of the square that is "cut off" by the angle, and then
2. trim the segment of the angle line that extends beyond the right-side of the square.
How do I do this? I'm new to Qcad and cad in general.
Thank you!
Phil Smith
Duluth, GA