Offset
Moderator: andrew
-
- Registered Member
- Posts: 2
- Joined: Wed Jun 25, 2008 12:38 am
- Location: Nashville,TN
Offset
I am sure this has been covered many times but I am new to Qcad, in from R14, Where is the offset command, and is there a print friendly manual?
Re: Offset
Try the command 'offset' or Draw - Line - Parallelroguepoint wrote:I am sure this has been covered many times but I am new to Qcad, in from R14, Where is the offset command,
http://www.ribbonsoft.com/qcad_doc.htmlroguepoint wrote: and is there a print friendly manual?