Hi all, I find Qcad easy to use and an excellent product, but am having problems inserting images. I am ending up with just a border with nothing in it. Doing somehing stupid but cannot solve it.
Any ideas out there please?
Drawing Images
Moderator: andrew
Most likely you are in draft mode.
See also:
http://www.ribbonsoft.com/qcad_doc_faq.html#12
-> 12. I can't see any hatches / large texts / bitmap images.
See also:
http://www.ribbonsoft.com/qcad_doc_faq.html#12
-> 12. I can't see any hatches / large texts / bitmap images.
-
- Newbie Member
- Posts: 7
- Joined: Tue May 29, 2007 10:28 am
Drawing Images
Yes draft mode !! What a prompt reply
Switching back and forth between draft mode made no difference and my settings are as shown (though mine are cm based).
I am probably just using the wrong command.
I am using the "dimaligned" command.
What I get is a line parallel to the original line with connection to the corners.
Looks like this (blue line is the dimensions layer):
I am probably just using the wrong command.
I am using the "dimaligned" command.
What I get is a line parallel to the original line with connection to the corners.
Looks like this (blue line is the dimensions layer):
Your dimension labels are too small.
Please refer to my answer to your original post:
http://www.ribbonsoft.com/rsforum/viewtopic.php?t=567
Please refer to my answer to your original post:
http://www.ribbonsoft.com/rsforum/viewtopic.php?t=567