Page 1 of 1

QIconvCodec warning when starting Qcad on linux system

Posted: Thu Feb 11, 2010 11:52 pm
by totoetsasoeur
Dear Sir,

When starting qcad, it returns the following warnings:

Code: Select all

~$ qcad
QIconvCodec::convertFromUnicode: using ASCII for conversion, iconv_open failed
QIconvCodec::convertToUnicode: using ASCII for conversion, iconv_open failed
I am wondering :
q1) what does it mean?
q2) what am I supposed to do to avoid this?

This is not a big deal as far as I have not observed any problem so far when using qcad.

Best regards.
Stephane

Posted: Mon Feb 15, 2010 10:06 am
by andrew
You can safely ignore it.