Numbers don't show on Command Line

If you are having problems with QCAD 2.1/2.2, post here. Please report bugs here.

Moderator: andrew

Locked
binto100
Registered Member
Posts: 2
Joined: Thu Feb 18, 2010 6:19 pm

Numbers don't show on Command Line

Post by binto100 » Mon Feb 22, 2010 11:17 pm

I posted this in the How To section w/o results so I'll try here.

Numbers I enter on the Command Line do not show up once the command is executed.

For example I enter @0,0 in the Command Line for the start of a two point line and press enter. The line starts correctly at the relative reference but @0,0 does not show in the Command Line history. Then I enter the end point via the Comman Line and again those numbers do not apprear in the Command Line history.

Any help would be appreicated. Thanks.

Bruce
Win7, Qcad 2.2

Locked

Return to “QCAD 2.1/2.2 Troubleshooting and Problems”