Page 1 of 1

Print problem with the 2.1.6.4 version

Posted: Tue Apr 01, 2008 1:14 pm
by david666
I used a hp1220c printer with cups on slackware 12.0
I work with 2.1.3.2 version and print with it or the next version without problem.
When i try to print with the last version this plan or another
[img=http://img406.imageshack.us/img406/3792 ... ht9.th.jpg]

i had this
[img=http://img241.imageshack.us/img241/9338 ... ez5.th.jpg]

Any idea ?

Thanks

Posted: Tue Apr 01, 2008 1:58 pm
by andrew
This is most likely a problem with the Qt version used for that release in combination with your printer driver / printer.

If you could contact us by e-mail, I'd like to send you a link to a pre-release of QCad 2.2, compiled with Qt 4.3.4 to see if the problem persists.

Thanks

Posted: Tue Apr 01, 2008 2:33 pm
by david666
I send you my email by your website contact

Thanks for your quick reply

Posted: Tue Apr 01, 2008 2:59 pm
by david666
I try your 2.0.0 pre version , and all seems good for the printer

Many thanks

Posted: Tue Apr 01, 2008 3:11 pm
by andrew
Great - thanks for letting me know. QCad 2.2 will be released in a few days.

Posted: Wed Apr 09, 2008 10:05 am
by The Punisher
Same printer here, HP1220C with Kubuntu 8.04.
I worked with V.2.1.3.2 without problems.
To see my printers on dialog i use the command: ln -sf /var/run/cups/printcap /etc/printcap.
After that, portrait and landscape printing were printed well.

On 2.1.6.4 my HP1220C stop to print in landscape mode.
My other Samsung Laser still print in landscape mode very well.

On HP1220C all my drawing are cutted on the right side; If I print A4 paper in landscape mode first 9cm are blank and next 21cm correctly printed in landscape mode with the drawing cutted on its right.

This is a scan of HP1220C A4 printed with 2.1.6.4
http://www.bilder-upload.eu/show.php?fi ... oNljkV.jpg

This is a scan of Samsung SCX-4521F A4 printed with 2.1.6.4
http://www.bilder-upload.eu/show.php?fi ... KHtLKb.jpg

I need my Hp1220C to print in A3 landscape.
Now I draw on 2.1.6.4 and print in 2.1.3.2; It's no good!

Posted: Fri Apr 11, 2008 3:29 pm
by The Punisher
Just tested the latest version 2.2.0.0

Printing problem solved.

Thanks Andrew for your effort.

Posted: Fri Apr 11, 2008 7:58 pm
by ttrw
andrew wrote:Great - thanks for letting me know. QCad 2.2 will be released in a few days.
Like usual, I can't find it anywhere! :?

Andrew, can you PM the link please?