Same problem here I think. Specifically saving a DXF file from QCad and the file cannot be loaded into TurboCad 12.5. TC hangs of all things. Prior to QCad saving the DXF file TC had no problems loading it. Windows or Mac version of QCad.
I need to be able to share DXF files for some laser cutting. This makes QCad impossible to use.
Can't load DXF files in TurboCad
Moderator: andrew
2 posts
• Page 1 of 1
Can't load DXF files in TurboCad
by ccpetersen » Sun Apr 20, 2008 3:08 pm
- ccpetersen
- Posts: 3
- Joined: Sun Apr 20, 2008 3:02 pm
More information
by ccpetersen » Sun Apr 20, 2008 6:19 pm
QCad DXF error:
AcDbMText(49). An invalid Line spacing style (0) was found. Validation: Not 1 or 2. Replaced by Set to 1.
AcDbMText(49). An invalid Drawing direction (0) was found. Validation: Not 1..5. Replaced by Set to 1.
AcDbMText(49). An invalid Line spacing style (0) was found. Validation: Not 1 or 2. Replaced by Set to 1.
AcDbMText(49). An invalid Drawing direction (0) was found. Validation: Not 1..5. Replaced by Set to 1.
- ccpetersen
- Posts: 3
- Joined: Sun Apr 20, 2008 3:02 pm
2 posts
• Page 1 of 1
Return to QCAD 2.1/2.2 Troubleshooting and Problems
Who is online
Users browsing this forum: No registered users and 1 guest