Problem with layers: block anchored to a layer.

If you are having problems with QCAD 2.1/2.2, post here. Please report bugs here.

Moderator: andrew

Problem with layers: block anchored to a layer.

Postby manoloba » Wed Apr 08, 2009 10:16 am

I put a block on a layer. But after turning on-off-on the display of each layer, I note that the block was changed to another layer.

After changing the properties of the block, to assig to correct layer, the block returns to the previous layer.

What could be the cause?

Any idea?

Thank you
manoloba
Newbie Member
 
Posts: 3
Joined: Wed Apr 08, 2009 9:30 am

Return to QCAD 2.1/2.2 Troubleshooting and Problems

Who is online

Users browsing this forum: No registered users and 2 guests

cron