Printer output is not what is seen on printpreview
Posted: Sun Sep 06, 2009 5:44 pm
Been using qcad for some time and never had this problem, but believe its down to me, but cannot figure it out.
When I print to my trusty hp 4400, after preview and fit and center to page, I get about a quarter of the drawing at the edge of the page.?
If I print to pdf and print the file it works great ?
Its me somewhere but am pulling my hair out, prssure is off now that I sussed pdf route but want to get it sorted properly.
Qcad ticks all the boxes for me!!
Any ideas appreciate.
With Thanks
Pete
When I print to my trusty hp 4400, after preview and fit and center to page, I get about a quarter of the drawing at the edge of the page.?
If I print to pdf and print the file it works great ?
Its me somewhere but am pulling my hair out, prssure is off now that I sussed pdf route but want to get it sorted properly.
Qcad ticks all the boxes for me!!
Any ideas appreciate.
With Thanks
Pete