I thought I would share this laser cut file for a card stock lantern, quite simply just cut out the four sides, glue together and job done. I guess for the very skilled you could use a craft knife (be careful).
laser cut 'Lantern' file
Moderator: andrew
1 post
• Page 1 of 1
laser cut 'Lantern' file
by clive » Fri Jun 01, 2012 4:39 pm
Hi guys
I thought I would share this laser cut file for a card stock lantern, quite simply just cut out the four sides, glue together and job done. I guess for the very skilled you could use a craft knife (be careful).
I thought I would share this laser cut file for a card stock lantern, quite simply just cut out the four sides, glue together and job done. I guess for the very skilled you could use a craft knife (be careful).
- Attachments
-
lantern .dxf- (1.05 MiB) Downloaded 112 times
-
- lantern.png (45.12 KiB) Viewed 1490 times
- clive
- Posts: 515
- Joined: Thu Aug 25, 2011 9:28 pm
- Location: UK
1 post
• Page 1 of 1
Return to Creating DXF/DWG items
Who is online
Users browsing this forum: No registered users and 1 guest