I can't get the create-polyline-from-segments tool to work even on a simple drawing with nothing else than lines that share one endpoint on a layer that is not locked. Am I doing something wrong or is this a bug? Should this also work with splines?
regards: Seppo Silaste
create polyline from segments not working?
Moderator: andrew
create polyline from segments not working?
Ubuntu 7.10 | QCad 2.2.2.0
Please note that there is no visual feedback for this tool. You can proceed like follows to check if the tool was successful:
1. Start tool to convert segments into a polyline.
2. Click any one of the segments.
3. Terminate tool (right click)
4. Click one of the segments. The whole polyline should now be selected and treated as one entity.
This tool does not work directly with splines. You need to explode the spline first and then convert the exploded segments into a polyline.
1. Start tool to convert segments into a polyline.
2. Click any one of the segments.
3. Terminate tool (right click)
4. Click one of the segments. The whole polyline should now be selected and treated as one entity.
This tool does not work directly with splines. You need to explode the spline first and then convert the exploded segments into a polyline.