Surveyor Bearings

Use this forum to ask questions about how to do things in the QCAD Community Edition.

Moderator: andrew

Surveyor Bearings

Postby Howard » Fri Jan 08, 2010 1:30 am

I'm new to QCAD and mostly familiar with AutoCAD and ProgeCAD. In these programs I can set units to 'surveyor units'. When I draw lines I can enter @125<N89d15'25"E to draw a line 125 feet long at this bearing. How do I accomplish the same in QCAD? Thanks.
Howard
Registered Member
 
Posts: 1
Joined: Fri Jan 08, 2010 1:05 am

Postby andrew » Fri Jan 08, 2010 9:43 pm

Surveyor angle input is not supported at this point in QCAD but will be most likely included in QCAD 3.

For now, you could use any mathematical formula, if that is helpful.
User avatar
andrew
Site Admin
 
Posts: 2544
Joined: Fri Mar 30, 2007 6:07 am

Postby wijit » Thu Feb 11, 2010 7:53 am

@125<89+15/60+25/3600 should give the same effect.
wijit
Newbie Member
 
Posts: 9
Joined: Sun Nov 15, 2009 4:30 pm


Return to QCAD Community 'How Do I' Questions

Who is online

Users browsing this forum: No registered users and 1 guest

cron