Use this forum to ask questions about how to do things in the QCAD Community Edition.
I'm new to QCAD and mostly familiar with AutoCAD and ProgeCAD. In these programs I can set units to 'surveyor units'. When I draw lines I can enter @125<N89d15'25"E to draw a line 125 feet long at this bearing. How do I accomplish the same in QCAD? Thanks.
- Registered Member
- Posts: 1
- Joined: Fri Jan 08, 2010 1:05 am
Surveyor angle input is not supported at this point in QCAD but will be most likely included in QCAD 3.
For now, you could use any mathematical formula, if that is helpful.
- Site Admin
- Posts: 3183
- Joined: Fri Mar 30, 2007 6:07 am
@125<89+15/60+25/3600 should give the same effect.
- Newbie Member
- Posts: 9
- Joined: Sun Nov 15, 2009 4:30 pm
Return to QCAD Community 'How Do I' Questions
Who is online
Users browsing this forum: No registered users and 0 guests