An easier way to modify entities (rectangles)

Please use this forum to post feedback and suggestions related to QCAD Professional.

Moderator: andrew

Locked
Jesusfreak
Newbie Member
Posts: 4
Joined: Fri Jun 15, 2007 9:32 pm

An easier way to modify entities (rectangles)

Post by Jesusfreak » Fri Jun 15, 2007 11:21 pm

Hi,
when I draw a rectangle and try to modify its properties afterwards I have to modify every single line of it. Doing so is pretty time consuming. I would suggest to change this in a way the user only has to change the two points diagonal to each other.

Regards
Jens

webrider
Active Member
Posts: 31
Joined: Sun May 27, 2007 5:31 pm
Location: Florida, USA

Post by webrider » Sun Jun 17, 2007 4:19 am

You didn't specify if you want to change line properties or the rectangle dimensions. The Edit>Stretch Entities tool may be worth looking into, as a solution to changing the rectangle dimensions.

Jesusfreak
Newbie Member
Posts: 4
Joined: Fri Jun 15, 2007 9:32 pm

Post by Jesusfreak » Tue Jun 19, 2007 2:58 pm

webrider wrote:You didn't specify if you want to change line properties or the rectangle dimensions. The Edit>Stretch Entities tool may be worth looking into, as a solution to changing the rectangle dimensions.
I tried it the way you described and it worked.

Thanks
Jesus

Locked

Return to “QCAD 2.1/2.2 Suggestions and Feedback”