I've been using qcad for a little while and am very happy with it.
I just purchased the prof. edition to support ribbonsoft (v220.127.116.11) and have found that I still have problems with text with special characters.
I'm running qcad on Ubuntu 10.10, 32-bit..
- won't write danish characters (æøå) on the drawing - they look fine in the text window.
v18.104.22.168 solves (1) - but
- Won't show certain special chars f.ex. superscript 1 and 2 (I guess it is those - 3,4,5,6.. is just below and look fine).
- Won't show correctly display special chars (such as "(4)", Degrees symbol etc.) - even though they look fine in the popup text window. They are displayed as ?
Any ideas as to what I could try?
If you are having problems with QCAD 2.1/2.2, post here. Please report bugs here.
2 posts • Page 1 of 1
The fonts of QCAD don't contain all glyphs. You can extend a font if required by loading it with QCAD. See also:
Who is online
Users browsing this forum: No registered users and 1 guest