Edit/Chamfer or Edit/Round button pressing

Please use this forum to post feedback and suggestions related to QCAD Professional.

Moderator: andrew

Edit/Chamfer or Edit/Round button pressing

Postby Latch » Sat Feb 19, 2011 5:47 pm

With an accidental 2 button press on either the Chamfer/Bevel button or the Round button it is possible to get Radius, Length 1, Length 2 to all show up on the Options Toolbar together.
It can happen when switching between these two buttons.
There seems to be no effect on the results of either intended operation, but it is a bit confusing if it happens.
Latch
Newbie Member
 
Posts: 4
Joined: Tue Feb 15, 2011 4:57 pm

Return to QCAD 2.1/2.2 Suggestions and Feedback

Who is online

Users browsing this forum: No registered users and 0 guests