scruffydog wrote:Please forget question (1) above. I think it is asking too much of the software.
Question (2) is still very important to me. It is necessary to figure out where to place nails equidistant to each other along a curve or line.
For question 1.
In this example you can see the areas that need to be modified.
By using the Modify > Breakout segment tool you can 'clean up' your drawing.
For question 2
Follow the prompts given in the command line:
Specify the target point -pick or enter in command line @1,0.
Choose correct option in the dialog window that opens (multiple copies).
*Use the same procedure for Arcs.
The following link may also help:viewtopic.php?f=32&t=1122