XP/32 QCAD 3.3.2
Right now, during my session, I get a couple Autosave warnings. Why is that so? I'm working on attributes ...
Autosave warning ...
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Re: Autosave warning ...
Three entities cannot be saved (the Teigha plugin reports an exception).
To check which ones, you can save the drawing under a new name and open it again in a new tab.
Such errors are due to invalid entities.
Ideally, this should not happen, as QCAD should prevent you from creating invalid entities. If you can figure out what type of entities were not saved, that might be helpful for me to fix the problem.
To check which ones, you can save the drawing under a new name and open it again in a new tab.
Such errors are due to invalid entities.
Ideally, this should not happen, as QCAD should prevent you from creating invalid entities. If you can figure out what type of entities were not saved, that might be helpful for me to fix the problem.
Re: Autosave warning ...
Ok - the bad boy (entity) seems to be a line in a Library item.
If I insert this item ones in my drawing - I get one Saving Warning.
If I put the same item 5 times in my drawing - I get 5 warnings with 5 different numbers.
If I insert this item ones in my drawing - I get one Saving Warning.
If I put the same item 5 times in my drawing - I get 5 warnings with 5 different numbers.
Re: Autosave warning ...
Thanks for the update. Can you attache that library item for testing? Thanks.
Re: Autosave warning ...
Here it is:
Manual / Auto-save provides this warning:
Manual / Auto-save provides this warning:
Re: Autosave warning ...
Thanks. It's a problem with the attributes that are created when the part is inserted. Their layer IDs can end up being invalid:
http://www.qcad.org/bugtracker/index.ph ... ask_id=932
Should be fixed for the next update, thanks for the report!
http://www.qcad.org/bugtracker/index.ph ... ask_id=932
Should be fixed for the next update, thanks for the report!
Re: Autosave warning ...
Nice, thank you!andrew wrote:Should be fixed for the next update