My dream script is to select a closed contour, enter a path spacing (tool width) and have a spiral path appear to the center. Only lines would be fine, any arcs around the outer could be finished manually. It would save me a lot of time on new designs.
The maths involved is a bit beyond me.
Thanks
Stephen.
Request - Closed contour area mill path.
Moderators: andrew, Husky, J-J
Re: Request - Closed contour area mill path.
Here is the example of what I wish. This all done manually.
This mill path uses my Cam config script with details in the layer names as you can see.
srl
This mill path uses my Cam config script with details in the layer names as you can see.
srl
- Attachments
-
- Screenshot-1.png (185.07 KiB) Viewed 16863 times
Re: Request - Closed contour area mill path.
Now done.
viewtopic.php?f=74&t=2601&start=15#p9702
It took a bit of problem solving.
I only have a little more work to do with the ramp off.
srl
viewtopic.php?f=74&t=2601&start=15#p9702
It took a bit of problem solving.
I only have a little more work to do with the ramp off.
srl