FS#1162Show Large Cross Hairs - not working
- Type
- Bug
- Status
- Closed
- Resolution
- Not a bug
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.7.5
- Operating system
- All
- Reported
- 2015-01-12 by anonymous
- Closed
- 2015-01-12 by andrew
Setting to show Large Cross Hairs fails, even after a restart.
Comments (3)
I cannot reproduce this here. Perhaps, you are expecting something else from this preference? The setting should give you a large crosshair for the mouse cursor when in snapping mode (e.g. when drawing a line, etc).
If you cannot solve it, could you post a screenshot while drawing lines? Thanks.
Ah, that's weird it's working again now.
OK, thanks. Perhaps, you accidentally ticked the wrong cross hair preference (for the absolute zero point).