FS#2411 : Report hatching loop errors in the user defined coordinate format

Status Closed
Percent Complete
100%
Task Type Feature Request
Category QCAD (main)
Assigned To

andrew
Operating System All
Severity Low
Priority Very Low
Reported Version 3.27.8
Due in Version Undecided
Due Date Undecided
Votes
1
- CVH (17.10.2022)
Private

Attached to Project: QCAD Bugtracker
Opened by CVH - 17.10.2022
Last edited by andrew - 21.10.2022

FS#2411 - Report hatching loop errors in the user defined coordinate format

Andrew,

In “Loop not closed at point 120.079/259.997.” we can not use the coordinate as such.
With my preferences I would need 120,079;259,997 as a valid coordinate to enter in the command line.
I do this ‘translation’ in between in Notepad.

Not that personally my boundaries are frequently off ;-)

Reported by <OttoZ> in:
https://www.qcad.org/rsforum/viewtopic.php?f=89&p=38836#p38829
‘Die Koordinaten lassen sich nicht kopieren, sonst könnte man zur Fehlstelle springen.’

In all cases the “/” is not a valid Cartesian coordinate separator.
The dot at the end of the sentence is also not so common in QCAD.

Regards,
CVH

Closed by andrew
21.10.2022 07:08
Reason for closing: Duplicate
Additional comments about closing:

FS#1977