FS#2411 - Report hatching loop errors in the user defined coordinate format
Andrew,
In “Loop not closed at point 120.079/259.997.” we can not use the coordinate as such.
With my preferences I would need 120,079;259,997 as a valid coordinate to enter in the command line.
I do this ‘translation’ in between in Notepad.
Not that personally my boundaries are frequently off 
Reported by <OttoZ> in:
https://www.qcad.org/rsforum/viewtopic.php?f=89&p=38836#p38829
‘Die Koordinaten lassen sich nicht kopieren, sonst könnte man zur Fehlstelle springen.’
In all cases the “/” is not a valid Cartesian coordinate separator.
The dot at the end of the sentence is also not so common in QCAD.
Regards,
CVH
Duplicate: www.qcad.org/bugtracker/index.php?do=details&task_id=1977