QCAD Bugtracker

  • Status Closed
  • Percent Complete
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.4.5
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by William Swanson - 31.12.2013
Last edited by Andrew - 28.04.2018

FS#1002 - Move/Rotate does not remember last-used angle

Steps to reproduce:

  1. Select an entity
  2. Activate the move/rotate tool (MR)
  3. Enter some angle into the dialog box
  4. Hit OK
  5. Repeat steps 1-2
  6. Notice that the angle that was entered in step 3 is not remembered, but that the dialog box always contains the same default angle.

Expected results:

The angle entered in step 3 should be remembered between invocations of the tool, just as it is for the plain rotate tool.

Closed by  Andrew
28.04.2018 06:30
Reason for closing:  Fixed
William Swanson commented on 31.12.2013 20:27

I forgot to mention, this has been broken since at least 3.1.2, and maybe earlier - well over a year now.

Husky commented on 31.12.2013 20:40


it works just fine for me. No default angle and the given angle is remembered correctly ...

William Swanson commented on 31.12.2013 20:51

Ah, I see what the difference is. The version set in the toolbar is remembered, but the version set in the dialog box is not.

Husky commented on 28.04.2018 04:53

I assume this can be closed now.


Available keyboard shortcuts


Task Details

Task Editing