- Status Assigned
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.6.3
- Due in Version 4.0.0
-
Due Date
Undecided
-
Votes
1
- CVH (26.10.2022)
- Private
Attached to Project: QCAD Bugtracker
Opened by Husky - 17.08.2014
Last edited by Andrew - 27.07.2015
Opened by Husky - 17.08.2014
Last edited by Andrew - 27.07.2015
FS#1087 - Ruler ticks are not corresponding to the grid points
Ruler ticks are not corresponding to the grid points,
Ruler will completely disappear at a certain zoom level,
Settings:
Drawing unit: inch,
Grid settings: Grid 1, Meta Grid 12,
Dim Label Format: “Engineering, 0’-0.0”
see topic below:
http://www.qcad.org/rsforum/viewtopic.php?f=32&t=3014
Postponed to next major release: