- Status Assigned
- Percent Complete
- Task Type Feature Request
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version Development
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
FS#1130 - Offset Polyline from both sides at once
It would be great to have a tick box to be able to offset a polyline from both sides/edges at once.
Maybe a similar feature could be added to the line -parallel tools?
Offset both sides of an open Polyline/Spline is implemented under Misc .. Modify.
Depending on the indicated position there is even an semi-circle added at the ends.
The Preview for Splines may be off but the result is fine.
It seems there is only one offset for Lines-Arcs-Circles-Ellipses ...
It seems that it offsets text entities very partially ...
There may be many 'Result loop not closed' or 'No offsets possible' warnings ...
Also see: FS#2415
Regards,
CVH