- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System Linux (All / Other)
- Severity Low
- Priority Very Low
- Reported Version 3.10.0
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Christian Aigner - 01.10.2015
Last edited by Andrew - 01.10.2015
Opened by Christian Aigner - 01.10.2015
Last edited by Andrew - 01.10.2015
FS#1274 - "Select Contour" selects every connected object
Right now the “Select Contour” feature behaves like a “Select each and every connected line”.
I think that was not the intended purpose, so I report this as a bug.
I tested it on a honeycomb structure and instead of selecting just the outer contour it selected also every line inside the structure, which were connected to the contour.
This is expected behavior. If multiple entities connect to the clicked entity, the exact outcome is not defined.
There is currently no tool to specifically select the outermost or innermost contour.
Ah, ok, then I misinterpreted the word "contour". Thanks for clarifying this.