QCAD Bugtracker

  • Status Closed
  • Percent Complete
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
  • Operating System Linux (All / Other)
  • Severity Low
  • Priority Very Low
  • Reported Version 3.10.0
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Christian Aigner - 01.10.2015
Last edited by Andrew - 01.10.2015

FS#1274 - "Select Contour" selects every connected object

Right now the “Select Contour” feature behaves like a “Select each and every connected line”.
I think that was not the intended purpose, so I report this as a bug.

I tested it on a honeycomb structure and instead of selecting just the outer contour it selected also every line inside the structure, which were connected to the contour.

Closed by  Andrew
01.10.2015 15:42
Reason for closing:  Not a bug
Andrew commented on 01.10.2015 15:42

This is expected behavior. If multiple entities connect to the clicked entity, the exact outcome is not defined.
There is currently no tool to specifically select the outermost or innermost contour.

Christian Aigner commented on 01.10.2015 15:45

Ah, ok, then I misinterpreted the word "contour". :-) Thanks for clarifying this.


Available keyboard shortcuts


Task Details

Task Editing