- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System Mac OS X El Capitan (10.11)
- Severity Low
- Priority Very Low
- Reported Version 3.15.5
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Sam Kang - 01.09.2016
Last edited by Andrew - 06.09.2016
Opened by Sam Kang - 01.09.2016
Last edited by Andrew - 06.09.2016
FS#1468 - Custom patterns are not selectable from qcad
Hi,
I added a new custom pattern into patterns/metric folder
However, even after restarting QCAD, new pattern is not showing in hatch dialog.
Closed by Andrew
06.09.2016 06:16
Reason for closing: Not a bug
Additional comments about closing:
06.09.2016 06:16
Reason for closing: Not a bug
Additional comments about closing:
Caused by an error in the pattern
file.
Please attach both the drawing file (.DXF or .DWG) and the pattern file (.PAT).
Your drawing might not use metric resources or there might be an issue with your pattern file.
Thanks.
I have attached the test file. As you will see the drawing is in metric.
The pat file is stored in
/Applications/QCAD.app/Contents/Resources/patterns/metric
Just in case, I have also copied in imperial folder but the result is the same
cheers,
sam
circles.pat (2.4 KiB)
Thanks.
The pattern file contains an unexpected control character on the last line (0x1A, Substitute). If you delete that last line, it will load correctly (see attached).