QCAD Bugtracker

  • Status Closed
  • Percent Complete
  • Task Type Bug Report
  • Category QCAD/CAM
  • Assigned To
  • Operating System Windows 7
  • Severity Medium
  • Priority Very Low
  • Reported Version 3.18.1
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Tom Schouten - 25.10.2017
Last edited by Andrew - 25.10.2017

FS#1646 - 3.18 has a HATCH issue

If you pres the “hatch icon” then the word “hatch” appears in the command window, but. . . nothing happens.

But if you type “hatch” followed by “enter” then finally the Hatch Window pops up.

Closed by  Andrew
25.10.2017 07:51
Reason for closing:  Not a bug
Additional comments about closing:  

Please re-open if a new installation does not solve the problem.

Andrew commented on 25.10.2017 07:50

I cannot reproduce this here. Please wipe your installation and re install again into a new, empty directory. There might be a mixed installation of an older (⇐3.15.x) and a newer version on top of each other. This can happen if the older version was installed from ZIP or EXE and the newer from an MSI.


Available keyboard shortcuts


Task Details

Task Editing