- Status Assigned
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Very Low
- Priority Defer
- Reported Version 3.19.2
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Husky - 20.02.2018
Last edited by Andrew - 21.02.2018
Opened by Husky - 20.02.2018
Last edited by Andrew - 21.02.2018
FS#1719 - Undo on converted drawing leads to wrong label position.
Drawing converted from inch to mm - undo leads to wrong dim label position. I can fix that with “Reset Label position” but it would be nice if QCAD could to that in first place.
For some reason, I cannot reproduce with any other drawing.
Please try this:
Default Template starts in mm / dimension setting decimal,
Converted to inch, changed Dimension settings from decimal to fractional,
later ... converted to mm which then shows the effect like the posted screenshot. I assume it has somewhat to do with the DIM setting "Fractional".
Another example:
Start with template in mm / decimal ... worked on the drawing,
converted to inch - still decimal,
undo .... leads again to wrong dim positioning but not that bad like the first "Fractional" example.