QCAD Bugtracker

  • Status Assigned
  • Percent Complete
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
  • Operating System All
  • Severity Very Low
  • Priority Defer
  • Reported Version 3.19.2
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Husky - 20.02.2018
Last edited by Andrew - 21.02.2018

FS#1719 - Undo on converted drawing leads to wrong label position.

Drawing converted from inch to mm - undo leads to wrong dim label position. I can fix that with “Reset Label position” but it would be nice if QCAD could to that in first place.

Andrew commented on 21.02.2018 09:50

For some reason, I cannot reproduce with any other drawing.

Husky commented on 21.02.2018 18:55

Please try this:
Default Template starts in mm / dimension setting decimal,
Converted to inch, changed Dimension settings from decimal to fractional,

later ... converted to mm which then shows the effect like the posted screenshot. I assume it has somewhat to do with the DIM setting "Fractional".

Another example:
Start with template in mm / decimal ... worked on the drawing,
converted to inch - still decimal,
undo .... leads again to wrong dim positioning but not that bad like the first "Fractional" example.


Available keyboard shortcuts


Task Details

Task Editing