QCAD Bugtracker

  • Status Closed
  • Percent Complete
  • Task Type Feature Request
  • Category QCAD (main)
  • Assigned To
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.20.1
  • Due in Version Undecided
  • Due Date Undecided
  • Votes 1
    • CVH (31.05.2018)
  • Private
Attached to Project: QCAD Bugtracker
Opened by CVH - 02.05.2018
Last edited by Andrew - 15.12.2020

FS#1749 - Add support for non-uniform block scaling

Same txt as on the forum.
had a copy because i had to log in 3 times to remark my own post.

Blocks are no solution either.

see pdf
[attachment=0]Block test_1.pdf[/attachment]

Antartica is put in a block as segments.
Added a rounded corner as segments and as poly.
scaled X x0.5 Y x1 origin the center of the magenta circl.

The scaled version is all over the place.
Set them to color red, no use they stay black.

The reference of the block is 2000mm to the left because I tried it out far right of my design.
The cyan circle is about 400mm in diameter.

dxf part included
[attachment=1]Block test.dxf[/attachment]

Version: (3.20.1)
Internet: QCAD.org
Build Date: Apr 13 2018
Revision: dd51609
Qt Version: 5.5.1
Architecture: i386
Compiler: MSVC++ 10.0 (2010)


Closed by  Andrew
15.12.2020 12:39
Reason for closing:  Fixed
Andrew commented on 02.05.2018 12:52

I can confirm that support for non-uniform block scaling is limited to lines at this point.

Andrew commented on 02.05.2018 12:53
CVH commented on 14.05.2018 08:27

See also FS#622 and  FS#454  and  FS#482 

Probably related FS#700


Available keyboard shortcuts


Task Details

Task Editing