QCAD Bugtracker

  • Status Closed
  • Percent Complete
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.20.1
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by CVH - 20.05.2018
Last edited by Andrew - 25.05.2018

FS#1761 - Info Polyline area does not find polylines (II)

Selecting Info // Polyline area
And hovering over a drawing with all kinds of entities.
Does not find any polyline on the drawing hovering over them.
Nor clicking on them.

Not a locked layer issue.
All are visible.

Closed by  Andrew
25.05.2018 15:19
Reason for closing:  Not a bug
Andrew commented on 21.05.2018 08:42

I cannot reproduce. Please attach drawing file if possible.

Note that this tool outputs the polyline area into the command line history by default (output can also be added to drawing as text). If the command line is off, there might not be any visible output when clicking a polyline.

CVH commented on 21.05.2018 09:27

Close it or change it to feature request.
Assumed similar behaviour as IR & IC. (are in same section)
Tried to use it as a faster way to detect minute differences in similar areas by just hovering over them. Will place some 200 values on my drawing then.

BTW: Related: Did you read solution to  FS#1756  on https://www.qcad.org/rsforum/viewtopic.php?f=31&t=5590


Available keyboard shortcuts


Task Details

Task Editing