- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD/CAM
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.21.3
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Arno Humbet - 07.11.2018
Last edited by Andrew - 20.11.2018
Opened by Arno Humbet - 07.11.2018
Last edited by Andrew - 20.11.2018
FS#1816 - TAB function in CAM module fails
When using (adding a TAB on a radius fails).
Example:
When length of the TAB is set to 1 mm.
After export to *.nc code the code is not ok.
And then check this is NC viewer or gcode sender the length is not set to 1 mm but is smaller.
On a line this function (TAB) is correct working.
Closed by Andrew
20.11.2018 08:59
Reason for closing: Won't fix
Additional comments about closing:
20.11.2018 08:59
Reason for closing: Won't fix
Additional comments about closing:
No further information received, no file
provided. Please re-open and attach file
if problem persists.
Please attach your drawing file (DXF), thanks.